Directions to:
ILEX Baltimore
ILEX Charlottesville
ILEX Easton
ILEX Middleburg
Ridgely Street Plant (ILEX Woodworking)
Browne (Architectural Millwork)

Directions to ILEX:
RIDGELY STREET PLANT
(ILEX Woodworking)
1700 Ridgely Street
Baltimore Maryland 21230
Phone: 410-837-8167 (ext. 347)
Fax: 410-837-0625

Directions from North of Baltimore:

1. Take 95 South to Baltimore to Fort McHenry Tunnel ($1.00 toll).
2. Stay in furthest right hand lane/right hand tube of the tunnel, you will be making a right hand exit immediately after exiting the tunnel.
3. Go through Fort McHenry Tunnel and take the first exit on the right, Exit 55.
4. Follow this long ramp which crosses underneath Rt. 95 until you reach Hanover Street.
5. Turn right on Hanover Street. and travel approximately 7 blocks to Hamburg Street.
6. Turn left onto Hamburg Street. Travel over the bridge to Russell Street.
7. Turn left onto Russell Street and proceed over the bridge.
8. Turn right at Bayard Street, then left on Ridgely Street.
9. The building for ILEX is on the corner of Bush & Ridgely Streets. Shop entrance is half way down the side of the building.

Directions from Easton, MD (From 97):

1. Take 97 North.
2. Take 695 toward Towson.
3. Take Exit 7B – 295N to Baltimore City.
4. Come into Baltimore, pass under 95, get over in right lane (merges with Russell Street exit from 95) and go through the first stop light.
5. Turn right onto Haines Street (between the BP gas station and the hotel).
6. Go 1 block & turn left onto Warner Street.
7. Go 1 block & turn left onto Bayard Street.
8. Go through the stoplight plus 1 block and turn left onto Ridgely Street.
9. Go 1 block to a stop sign (@ Bush Street).
10. Proceed forward across Bush Street into a parking lot. The big white building on your right is 1700 Ridgely Street. In the middle of the building there is a green entry door. That is the entry door to our manufacturing plant.

Directions from South of Baltimore, MD:

1. 95 North inside the beltway (695) to Russell Street exit (Exit 52). This exit puts you on Russell Street going north.
2. Take the first right just past the gas station onto Haines Street.
3. Go 1 block & turn left onto Warner Street.
4. Go 1 block & turn left onto Bayard Street.
5. Go through the stoplight plus 1 block and turn left onto Ridgely Street.
6. Go 1 block to a stop sign (@ Bush Street).
7. Proceed forward across Bush Street into a parking lot. The big white building on your right is 1700 Ridgely Street. In the middle of the building there is a green entry door. That is the entry door to our manufacturing plant.